Strong SRT 7300 CI+ User Manual page 14

PART 1 • English
Scrambled:
Service Type All:
TV scan:
Radio:
Network Search Disabled: no network search
Enabled:
Once all settings are made, press the gREEn button on the remote control to start the scan or EXIT to
quit without scanning. All newly found channels will be stored at the end of the channel list.
Tip:
7.1.3 manual scan
Use this menu to scan a single transponder only.
The following can be set: Satellite, Transponder, Frequency, Polarisation, Symbolrate, Scan Mode, Service
Type and Network search. Use pq to move the highlight to the chosen setting and tu to change its
value. Once all settings set correct, press the gREEn button to start scanning or EXIT to quit. All newly
found channels will be stored at the end of the channel list.
note:
7.1.4 satellite Edit
Here you can edit transponder data or add a new satellite.
On the left of the screen, a list with all available satellites is displayed. The right of the screen displays a
list will all available transponders for the highlighted satellite.
Adding or editing a transponder
Use pq to highlight the desired satellite. Press u to move the highlight to the transponder list. Press
YElloW to add a transponder or use pq to highlight the transponder to be edited and then press
blUE to enter the edit screen. Use pq to navigate in the edit screen and use tu respectively [0~9] to
change the settings. Once all settings are made, press gREEn to save or EXIT to quit without saving.
Editing an existing satellite
Use pq to highlight the satellite you wish to edit. Press blUE to go to the Satellite Edit screen. To edit
the name of the satellite, use pq to highlight the name and press ok. A keyboard will pop up. Use pq
tu to navigate and ok to input the chosen character. Once finished press gREEn to save the changes
or EXIT to quit without saving. To edit the position of the satellite, use pq to move the highlight
to Position and use the [0~9] buttons to input the new position. To change the location, use pq to
scan scrambled channels only.
scan TV and Radio channels
TV channels only
scan radio channels only.
network search will be performed.
network search: If Disabled is selected, the receiver will search only for
channels available from the preset transponder list of the selected satellite. If
it is set to Enabled, the receiver will perform an additional search for channels
from the NIT table (NIT= Network Identification Table). Use this option to
receive new launched channels from the selected satellite.
Press YElloW in the Manual Scan menu to make settings for a PID search.
Scan mode, Service type and Network search will then be replaced by settings for
Video PID, Audio PID and PCR PID. For information on PID values, please visit
websites like: www.lyngsat.com or www.kingofsat.net
11