Enabling The Service Processor Network Management Port - Fujitsu SPARC Enterprise T5140 Installation Manual

psrinfo – Displays information about the number and status of the processors
■
and cores in the host.
prtdiag – Displays system configuration and diagnostic information.
■
Review the Solaris OS man pages and documentation for more details.
Related Information
"Enabling the Service Processor Network Management Port" on page 49
■
Solaris OS documentation
■
SPARC Enterprise T5140 and T5240 Servers Administration Guide.
■
Enabling the Service Processor Network
Management Port
The service processor network management port is not operational unless your
network employs DHCP, in which case the configuration in automatic. If your
network uses DHCP, you can run this command to view your server's network
configuration information:
-> show /SP/network
For example,
-> show /SP/network
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = 10.8.31.5
ipaddress = 10.8.31.188
ipdiscovery = dhcp
ipgateway = 10.8.31.248
ipnetmask = 255.255.252.0
macaddress = 00:14:4F:7E:83:4F
pendingipaddress = 10.8.31.188
pendingipdiscovery = dhcp
pendingipgateway = 10.8.31.248
pendingipnetmask = 255.255.252.0
state = enabled
Powering On the System 49