Fujitsu SPARC Enterprise T5140 Installation Manual page 80

Starting /SYS
->
c. Switch to the system console to view POST output.
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
.
.
.
.
.
.
2007-12-14 16:34:53.385 0:1:0>INFO:
2007-12-14 16:34:53.391 0:1:0>
2007-12-14 16:34:53.399 0:1:0>POST:
2007-12-14 16:34:53.406 0:1:0>Master set ACK for vbsc runpost
command and spin.
...
SPARC Enterprise T5240, No Keyboard
Copyright 2007 Sun Microsystems, Inc.
OpenBoot 4.27.x, 3968 MB memory available, Serial #74409918.
Ethernet address 0:14:4f:6f:67:be, Host ID: 846f67be.
{8} ok
2. Type the console escape sequence (by default #. (Hash-Period)) to return to the
ILOM prompt.
3. Check the POST execution result with the following command:
-> show /SP/faultmgmt -level all
Note – Depending on the configuration of ILOM, POST variables, and whether
POST detected faults or not, the server might boot, or the system might remain at the
ok prompt. If the system is at the ok prompt, type boot.
58 SPARC Enterprise T5140 and T5240 Servers Installation Guide • July 2009
Watch the POST output for possible fault messages. The following output is a
sign that POST did not detect any faults. The message indicating successful
passage of POST is indicated in bold.
To stop, type #.
POST Passed all devices.
Return to VBSC.
All rights reserved.