Fujitsu SPARC Enterprise T5140 Installation Manual page 48

a. At the front of the rack, plug the left side of the tool into slots at the end of
FIGURE:
b. Insert the right side of the tool into the front end of the right rail.
c. Slide the end of the rail to the right or left as needed to allow the ends of the
d. Tighten the screws to lock the ends of the rails in place.
e. At the rear of the rack, repeat
Related Information
"To Insert and Lock the Server in the Rack" on page 27
■
26 SPARC Enterprise T5140 and T5240 Servers Installation Guide • July 2009
the left rail.
Using the Slide Rail Spacing Tool to Adjust the Distance Between the Slide Rails
(Either Server)
tool to enter the ends of both rails.
The distance between the rails is now equal to the width of the server with
mounting brackets.
rails.
Step a through Step d for the rear ends of the