Using The Service Processor For Common Operations; To Perform A Normal System Initialization - Fujitsu SPARC Enterprise T5140 Installation Manual

Using the Service Processor for Common
Operations
The following topics are described in this section:
"To Perform a Normal System Initialization" on page 56
■
"To Examine the System for Faults" on page 57
■

▼ To Perform a Normal System Initialization

1. Type the start /SYS command.
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
2. To monitor the power on sequence, type the start /SP/console command.
You will see an ILOM CLI alert message on the system console. This message
indicates that the system has reset.
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
The CPU and memory controllers initialize, and eventually OpenBoot initializes.
After a number of system console messages, the ok prompt appears, or the system
will boot into the Solaris OS.
Note – System behavior (such as whether the system halts at the ok prompt or boots
to the Solaris OS) depends on how the auto-boot variable is set. See the SPARC
Enterprise T5140 and T5240 Servers Administration Guide for more information.
The following example output is a small section of the complete output.
0:1:0>
0:1:0>SPARC-Enterprise[TM] T5140/T5240 POST 4.27.x.
2007/12/11 18:55
...
56 SPARC Enterprise T5140 and T5240 Servers Installation Guide • July 2009
To stop, type #.