Note – You can type the show /SP/network command again (after performing the
set /SP/network commitpending=true command) to verify that the
parameters have been updated.
Related Information
"To Configure the Service Processor Network Management Port" on page 52
■
SPARC Enterprise T5140 and T5240 Servers Administration Guide
■
▼ To Log Into the Service Processor Using the
Network Management Port
Note – You must configure the service processor parameters shown in
the Service Processor Network Management Port" on page 52
network management port.
●
Open an SSH session and connect to the service processor by specifying its
network address.
% ssh root@xx.xxx.xx.x
...
Are you sure you want to continue connecting (yes/no)? yes
...
Password: password (nothing displayed)
Waiting for daemons to initialize...
Daemons ready
Integrated Lights Out Manager
Version 2.0.0.0
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
->
Related Information
"To Perform a Normal System Initialization" on page 56
■
"To Configure
before you can use the
Powering On the System
55