Enabling The System Controller Network Management Port - Fujitsu Sparc Enterprise T2000 Installation Manual

Sample System Controller Output (Continued)
CODE EXAMPLE 3-1
LOOPBACK
I2C
EPROM
FRU PROM
ETHERNET
MAIN CRC
BOOT CRC
TTYD
TTYC
MEMORY
MPC885
Please login:
Note – If it receives no user input within 60 seconds, the ALOM CMT system
controller console automatically connects to the system console.
Enabling the System Controller Network
Management Port
The system controller network management port is not operational until you
configure network settings for the system controller. Configure the system controller
in this order:
1. After the system controller boots, access the ALOM CMT command line interface
through the serial management port. See
Using the Serial Management Port" on page
2. Configure the system controller. See
Network Management Port" on page
3. Enable the new values by resetting the system controller. See
System Controller" on page
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
"To Configure the System Controller
39.
42.
"To Log Into the System Controller
38.
"To Reset the
Chapter 3 Powering On the System 37