To Examine The System For Faults - Fujitsu SPARC Enterprise T5140 Installation Manual

0:1:0>Network Interface Unit Tests....Done
0:1:0>Functional CPU Tests....Done
0:1:0>Extended Memory Tests....Done
2007-12-14 16:45:28.800 0:1:0>INFO:
2007-12-14 16:45:28.806 0:1:0>
2007-12-14 16:45:28.816 0:1:0>POST:
2007-12-14 16:45:28.824 0:1:0>Master set ACK for vbsc runpost
command and spin...
SPARC Enterprise T5240, No Keyboard
Copyright 2007 Sun Microsystems, Inc.
OpenBoot 4.27.x, 3968 MB memory available, Serial #74409918.
Ethernet address 0:14:4f:6f:67:be, Host ID: 846f67be.
{0} ok
Related Information
"To Examine the System for Faults" on page 57
■
Integrated Lights Out Manager (ILOM) 2.0 Supplement for SPARC Enterprise T5140
■
and T5240 Servers
Integrated Lights Out Manager (ILOM) 3.0 Supplement for SPARC Enterprise T5140
■
and T5240 Servers
SPARC Enterprise T5140 and T5240 Servers Administration Guide
■

▼ To Examine the System for Faults

1. Perform the following steps to verify that there are no faults:
a. Set the virtual keyswitch to diag mode so that POST will run in Service
mode.
-> set /SYS keyswitch_state=diag
Set 'keyswitch_state' to 'diag'
b. To initiate the power on sequence, type the start /SYS command.
You will see an ILOM CLI alert message on the system console. This message
indicates that the system has reset.
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
POST Passed all devices.
Return to VBSC.
All rights reserved.
Powering On the System 57