To Reset The System; To Power Cycle The System - Fujitsu SPARC Enterprise T5140 Installation Manual

SPARC Enterprise T5140 and T5240 Servers Administration Guide
■

▼ To Reset the System

●
If it is necessary to reset the system, use the shutdown -g0 -i6 -y command.
# shutdown -g0 -i6 -y
It is not necessary to power the system off and on to simply reset the system.
Related Information
"To Power Cycle the System" on page 62
■
SPARC Enterprise T5140 and T5240 Servers Administration Guide
■

▼ To Power Cycle the System

If a simple reset does not clear a system problem, you can power the system off and
on with this procedure.
1. Shut down the Solaris OS.
At the Solaris OS prompt, type the shutdown -g0 -i0 -y command. Then type
h when prompted to halt the Solaris OS and to return to the ok prompt.
# shutdown -g0 -i0 -y
# svc.startd: The system is coming down.
svc.startd: 91 system services are now being stopped.
Jun 12 19:46:57 wgs40-58 syslogd: going down on signal 15
svc.startd: The system is down.
syncing file systems... done
Program terminated
r)eboot, o)k prompt, h)alt?
2. Switch from the system console prompt to the service processor console prompt
using the console escape sequence (by default, #.
(Pound-Period)).
ok #.
->
62 SPARC Enterprise T5140 and T5240 Servers Installation Guide • July 2009
Please wait.