Connector Wiring Assignments
FIGURE:
Figure Legend
1
From -48V or -60V
2
From Chassis ground (green/yellow)
3
From -48V or -60V Return
Note – If you need to remove a wire from the DC input plug, insert the cage clamp
operating tool or a small screwdriver into the slot directly above the wire and push
in. Pull the wire from the DC input plug.
7. Remove the cage clamp tool to secure the wire.
8. Repeat the procedures for the other two wires to complete the assembly of the
DC input power cable.
9. Repeat this procedure to create as many DC input power cables as you need for
your unit.
Related Information
"To Connect the DC Input Power Cords to the Server" on page 102
■
Assembling and Installing DC Power Cables for the SPARC Enterprise T5240 Server
101