Attach The Cma - Fujitsu SPARC Enterprise T5440 Installation And Setup Manual

1. Attach one end of the CMA support strut to the lefthand slide rail.
2. Attach the other end of the CMA support strut to the righthand inner rail.
3. Slide the server in and out of the cabinet to ensure that the CMA support strut
is operating correctly.

▼ Attach the CMA

Note – References to "left" or "right" in this procedure assume that you are standing
behind the equipment rack and looking at the rear of the server.
Complete the following tasks:
"Installing the Rack Slide Assembly" on page 14
■
"Installing the Server Into the Cabinet" on page 19
■
"Attach the CMA Support Strut" on page 22
■
1. If necessary, slide the server back until it reaches the internal stops.
2. Fold the CMA as shown in
Folding the CMA
FIGURE:
FIGURE: Folding the CMA on page
Installing the SPARC Enterprise T5440 Server
23.
23