Fujitsu SPARC Enterprise T5440 Installation And Setup Manual page 54

■
■
■
■
Note – When you power on the server for the first time and you do not have a
terminal or terminal emulator (PC or workstation) connected to the service processor
serial management port, you will not see system messages.
2. (Optional) Connect an Ethernet cable between the server's Net MGT port
(FIGURE: Server Rear Panel Connections on page
future connections to the SP and host will be made.
After the initial configuration of the system using the SP SER MGT port,
communication with the SP and host is usually performed through this Ethernet
interface.
3. Connect an Ethernet cable between one of the server's NET ports
Server Rear Panel Connections on page
will communicate.
Note – If a 10 GBit Ethernet (XAUI) card is installed in the system, the
corresponding Ethernet port is disabled. For example, if a XAUI card is installed at
XAUI0, the NET0 port is disabled.
4. Plug the power cords into the power supplies and into a power source.
Note – Only two power connections are required for operation. Use four power
connections and two separate circuits for redundancy.
The service processor runs on the 3.3V standby voltage. As soon as AC power is
connected to the system, the service processor powers on, runs diagnostics, and
initializes the ILOM firmware.
After a few minutes, the SP login prompt appears on the terminal device. The host
is not initialized or powered on yet.
34 SPARC Enterprise T5440 Server Installation and Setup Guide • July 2009
8 bits
No parity
1 Stop bit
No handshake
A null modem configuration is needed, meaning the transmit and receive
signals are reversed (crossed over) for DTE to DTE communications. You can
use the supplied RJ-45 crossover adapters with a standard RJ-45 cable to
achieve the null modem configuration.
28) and the network to which
28) and the network to which the server
(FIGURE: