Optional Component Installation; Cabling Notes - Fujitsu SPARC Enterprise T5440 Installation And Setup Manual

Optional Component Installation

The standard components of the server are installed at the factory. However, if you
ordered options such as additional memory or PCI cards, these will be shipped
separately. If possible, install these components prior to installing the server in a
rack.
Note – The list of optional components can be updated without notice. See the
product web pages for the most current list of components supported in the server.
Related Information
If you ordered any options that are not factory-installed, see the SPARC Enterprise
■
T5440 Server Service Manual for installation instructions.

Cabling Notes

Minimum cable connections for the server:
■
At least one system on-board Ethernet network connection (NET port)
■
The service processor serial management port (SER MGT port)
■
The service processor network management port (NET MGT port)
■
Power cables for the system power supplies
■
Service processor management ports: There are two service processor
■
management ports for use with the ILOM service processor.
The service processor serial management port (labeled SER MGT) uses an RJ-45
■
cable and is always available. This port is the default connection to the ILOM
service processor.
The service processor network management port (labeled NET MGT) is the
■
optional connection to the ILOM service processor. This port is not available
until you configure network settings for the service processor (through the
service processor serial management port). See
Network Management Port" on page
management port uses an RJ-45 cable for a 10/100 BASE-T connection. This
port does not support connections to Gigabit networks.
See the SPARC Enterprise T5440 Server Overview Guide for more information.
"Enabling the Service Processor
37. The service processor network
Preparing for Installation 5