Fujitsu SPARC Enterprise T5440 Installation And Setup Manual page 24

Caution – There is a potential for electric shock if the server and related equipment
are not properly grounded.
8. After the service processor boots, access the ILOM command-line interface (CLI)
through the serial management port. See
Serial Management Port" on page
9. Configure the service processor network addresses. See
Processor Network Management Port" on page
Note – The service processor network management port is not operational until you
configure network settings for the service processor (through the service processor
serial management port).
10. Commit the changes to the service processor network parameters. See
"Power On the System for the First Time" on page
11. Power on the server from a keyboard using the ILOM software. See
the System" on page
12. Configure the Solaris OS. See
The Solaris OS is preinstalled on the servers. When you power on, you are
automatically guided through the Solaris OS configuration procedure.
13. Install any required patches to the server.
Refer to the SPARC Enterprise T5440 Server Product Notes for a list of required
patches.
14. Load additional software from the Solaris media kit (optional).
The Solaris media kit (sold separately) includes several CDs containing software
to help you operate, configure, and administer your server. Refer to the
documentation provided with the media kit for a complete listing of included
software and detailed installation instructions.
Related Information
"Tools and Equipment Needed" on page 2
■
"Safety Precautions" on page 10
■
"ESD Precautions" on page 11
■
"Installing the SPARC Enterprise T5440 Server" on page 13
■
"Powering On the System" on page 31
■
4 SPARC Enterprise T5440 Server Installation and Setup Guide • July 2009
"Log Into the Service Processor Using the
40.
45.
"Booting the Solaris Operating System" on page
"Configure the Service
41.
33.
"Power On
Step 2 in
49.