Fujitsu SPARC Enterprise T5440 Installation And Setup Manual page 62

2. Configure the service processor using information from your network
administrator.
Your choices are:
■
■
a. If you choose to use a dynamically created IP address (use DHCP to retrieve
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
b. If you choose to configure a static IP configuration. set the parameters
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
iii. Set the IP address for the service processor.
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
42 SPARC Enterprise T5440 Server Installation and Setup Guide • July 2009
dhcp - Set up the network connection with a dynamically created IP
configuration.
static - Set up the network connection with a static IP configuration.
the network setting), set pendingipdiscovery to dhcp.
pendingipdiscovery, pendingipaddress, pendingipgateway, and
pendingipnetmask as follows.
i. Set the service processor
ii. to accept a static IP address.
iv. Set the IP address for the service processor gateway.
v. Set the netmask for the service processor.
This example uses 255.255.255.0 to set the netmask. Your network
environment subnet might require a different netmask. Use a netmask
number most appropriate to your environment.