Fujitsu SPARC Enterprise T5440 Installation And Setup Manual page 55

5. At the terminal device, log in to the SP as root with a password of changeme.
XXXXXXXXXXXXXXXX login: root
Password: changeme
. . .
->
After a brief delay, the SP prompt is displayed (->). At this point, there are many
commands you can perform using the Integrated Lights Out Manager interface.
Additional SP information, such as how to change the password and how to set
up the SP network parameters is available in the online documentation set.
6. Power on the server and redirect the host output to display on the serial
terminal device:
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
-> start /SP/console
Are you sure you want to start /SP/CONSOLE (y/n)? y
Serial console started. To stop, type #.
. . .
After you start the SP console, the server initialization takes approximately 20
minutes to complete.
7. When prompted, follow the onscreen instructions for configuring the Solaris
Operating System on your host and enter the following configuration
information.
You will be prompted to confirm the configuration several times, enabling
confirmation and changes. If you are not sure how to respond to a particular
value, you can accept the default, and make future changes when the Solaris OS is
running. See TABLE: Reference for Solaris OS Configuration on page 36
description of the Solaris OS parameters you must provide during initial
configuration.
8. Log in to the server and explore its capabilities.
There are many commands you can use to verify the functionality of the system.
The following list describes a few of them:
showrev – Displays the hostname and system architecture information. Use the
■
-a option with this command to see the patches that are installed.
psrinfo – Displays information about the number and status of the processors
■
and cores in the host.
prtdiag – Displays system configuration and diagnostic information.
■
Review the Solaris OS man pages and documentation for more details.
for a
Powering On the System 35