Table of Contents
Advertisement
WARNING: You must oper-
ate this heater with the screen
in place. Make sure screen is
installed before running heater.
NOTICE: During initial operation of
new heater, burning logs will give
off a paper-burning smell. Orange
flame will also be present. Open
damper or window to vent smell.
This will only last a few hours.
1. STOP! Read the safety information, page
18.
2. Open screen.
3. Make sure equipment shutoff valve is fully
open.
4. Be sure the slide switch on the front of the
receiver box is in the REMOTE position.
5. Push in control knob slightly and turn
clockwise
Figure 20).
6. Wait five (5) minutes to clear out any gas.
Then smell for gas around heater and near
the floor. If you smell gas, STOP! Follow
"B" in the safety information, page 18. If
you do not smell gas, go to the next step.
7. Push in control knob slightly and turn coun-
terclockwise
Press in control knob for five (5) seconds.
Note: The first time that the heater is
operated after connecting the gas supply,
the control knob should be pressed for
about thirty (30) seconds. This will allow
air to bleed from the gas system. If pilot
does not stay lit, refer to Troubleshooting,
pages 27 though 29. Also contact a quali-
fied service technician or gas supplier for
repairs. Until repairs are made, light pilot
with match.
• If control knob does not pop up when
released, contact a qualified service
technician or gas supplier for repairs.
8. With control knob pressed in, push
down and release ignitor button. This
will light pilot. The pilot is attached to
the rear of the burner. If needed, keep
pressing ignitor button until pilot lights.
20
OPERATION
MODELS FBD400RTCC-M-HC/MO
LIGHTING INSTRUCTIONS
to the OFF position (see
to the PILOT position.
www.usaprocom.com
Note: If pilot does not stay lit, refer to
Troubleshooting, pages 27 though 29.
Also contact a qualified service technician
or gas supplier for repairs. Until repairs
are made, light pilot with match. To light
pilot with match, see Manual Lighting
Procedure, page 21.
9. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
Note: If pilot goes out, repeat steps 7
through 11. This heater has a safety inter-
lock system. Wait one (1) minute before
lighting pilot again.
10. Turn control knob counterclockwise
to the ON position. The main burner
should light.
Note: Please wait one minute after shut-
ting off heater to allow the control valve
to reset before starting again.
11. Press the LEARN button on the front of
the remote receiver box until you hear a
beep (see page 21).
12. Press teh ON button on the remote control
to light the burner. (This will also "learn"
or program the remote and receiver.)
Note: If the remote control is lost or dam-
aged, the slide switch on the receiver can
be used to operate the heater.
13. Make sure heater screen is in place before
operating heater.
14. If heater will not operate, follow the in-
structions To Turn Off Gas To Appliance,
and call your service technical or gas
supplier.
Ignitor
Remote
Receiver
Figure 20 - Heater Control Locations
Control
Knob
200020-01A
Hide quick links:
Advertisement
Table of Contents
