Remote Control System - Procom FBD400RTCC-M-HC/MO Owner's Operation And Installation Manual

CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Shutting Off Heater
Turn control knob clockwise
OFF position.
1. Open screen.
2. Follow steps 1 through 7 under Lighting
Instructions, page 20.
3. With control knob in the PILOT position,
strike a match, and hold near pilot. Press
in control knob; pilot should light.
Programming the Remote and Receiver
The remote and receiver must be "learned"
to one another.
1. Turn control knob on the heater to the ON
position.
2. Place the slide switch on the receiver in
the remote position (see Figure 21).
3. Use a pen or small screwdriver to gently
press and release the recessed LEARN
button on the face of the receiver. You will
hear a beep.
4. Press the ON button on the remote (see
Figure 22, page 22). You will hear a series
of beeps. Your appliance should come on.
Learn Button
LEARN
ON
Slide Switch
Figure 21 - Receiver
200020-01A
OPERATION
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE

REMOTE CONTROL SYSTEM

REMOTE OFF
www.usaprocom.com
WARNING: If input gas
type is NG, make sure NG pilot
burner ignites. If input gas type
is LP, make sure LP pilot burner
ignites.
Shutting Off Burner Only (pilot
to the
Turn control knob clockwise
PILOT position.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
5. Make sure the heater screen is in place
before operating heater.
Matching Security Codes
When matching security codes, be sure slide
switch on the receiver is in the REMOTE
position. To program the remote receiver
to LEARN a new security code, press and
release the LEARN button on the top of the
remote receiver, and then press ON or OFF
button on the transmitter. A change in the
beeping pattern at the receiver, indicates the
transmitter's code has been programmed into
the receiver.
Remote Control Operation
This appliance must not be used with glass
doors in the closed position. This can lead
to pilot outages and severe sooting outside
the fireplace.
The transmitter operates on 2 AAA batteries.
stays lit)
to the
21