Installation Instructions - Procom FBN280RHAC Series Owner's Operation And Installation Manual

READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION. Check to see that you have
the following. If any part or parts are missing, contact the dealer where you bought the sur-
round and hearth.
TOOLS REQUIRED:
Measuring Tape, Pencil, Level, #2 Phillips Screw Driver, Hammer, Electric Drill, 5/6" Drill Bit,
Hand or Electric Saw
INSTALLATION:
1. Surround must be installed flush with wall. Baseboards
wi ll pr event p ro per i nst al lat io n o f su rro un d.
Baseboards can be altered to fit surround by cutting
that part within 34 1/2" distance from the wall corner.
2. Surround must be attached to either a wall stud or wall
anchor. Use a tape measure to determine correct
height from floor to location of mounting strips. (See
Figure 1). Make sure point of the mitered edge of
mounting strip touches the corner. Use a level to en-
sure mounting strips are evenly balanced.
IMPORTANT: Failure to balance mounting strips
with a level could result in uneven surfaces on
fully assembled surround.
3. Fasten mounting strip to wall by inserting 2" screws
provided along the predrilled holes of mounting strip.
If predrilled holes of mounting strip do not line up with
wall studs, drill new holes where wall studs are or at-
tach to wall with wall anchors. (See Step 4 below.)
4. To use wall anchors, drill holes at marked location
using 5/16" drill bit. Fold wall anchor (see Figure 2)
and insert (wings first) into hole. Tap anchor flush into
wall. For thin walls, insert red key into wall anchor and
push to "pop" open anchor wings (see Figure 3).
5. Repeat steps above to attach other mounting strips
to wall. Make sure mitered edges fit together to form
a clean joint in the corner of the wall.

INSTALLATION INSTRUCTIONS

For CORNER SURROUND AND HEARTH
22
19 1/2"
19 1/2"
Figure 1
Figure 2
Figure 3