Table of Contents
Advertisement
Pin for Log #5
Log #4
Figure 15 - Installing Log #4
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the
type and quantity stated in table below.
• Do not mix old and new batteries. New bat-
teries should be the same brand for best
results.
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installa-
tion may void the warranty on the product.
• For remote control systems, maximize bat-
tery life by turning off the receiver when it
is not in use.
• For long periods of non-operation, remove
batteries from all components for safety.
Component
Ignitor
Remote Control
Remote Receiver
*Note: Quantity depends on model of remote
control.
200020-01A
INSTALLATION
Hole for Log #6
INSTALLING BATTERIES
Type of Battery
Qty.
AAA
AAA
2 or 3*
AA
www.usaprocom.com
Log #5
Figure 16 - Installing Log #5 and #6
Unscrew ignitor cap and install a AAA battery
with the + pointing out. Replace cap.
Figure 17 - Installing Battery in Ignitor
Receiver and Remote Control
Batteries are required in both the Remote
Control (Transmitter) (2 AAA size) and Re-
ceiver (4 AA size) (see Figure 18).
Note: Be sure batteries are placed correctly.
Reversing the batteries can cause damage to
the receiver and remote. Replace all batteries
on a yearly basis or sooner.
1
4
Figure 18 - Installing Batteries in Remote
Log #6
Ignitor
AAA
Battery
Positive
UP
Receiver
Remote Control
(Transmitter)
Control and Receiver
17
Hide quick links:
Advertisement
Table of Contents
