5.22
Rate Limiting
Rate limiting allows you to set up the bandwidth rate and packet limitation type per port.
Ingress Limit Packet Type – select the packet type to be filtered. The packet types
include four types of packets: all, broadcast/multicast/flooded, unicast packets,
broadcast/multicast packets, and broadcast only packets. The egress rate supports
all types of packets.
All ports support port ingress and egress rate control. For example, if Port 1 is
10Mpbs, users can set its effective egress rate at 1Mbps and ingress rate is 500kbps.
The switch performs the ingress rate by packet counter to meet the specified rate.
Ingress – enter the port effective ingress rate. The default value is 0.
Egress – enter the port effective egress rate. The default value is 0.
Click Apply to confirm the settings.
Waters Network Systems
Figure 5.22 – Rate Limiting
GSM2109-1009-8PoE User's Manual
Page 50