Security Configuration - Waters Network Systems GSM2109-1009-8PoE Operating Manual

Note: When the X-ring function is enabled, RSTP must be disabled. The X-ring
function cannot exist at the same time as RSTP. Remember to save configuration so
the new settings will be saved if the switch loses power.
5.29 802.1X - Security Configuration
Use the Security menu to configure 802.1x and port security by MAC address. 802.1x
is an IEEE network standard that allows a client to connect to a wireless access point or
wired switch, but prevents the client from gaining access to the Internet until proper
authentication has taken place.
password which are verified by a separate server.
802.1x/Radius
Once the 802.1x function has been enabled, you are ready to configure the parameters
for this function.
IEEE 802.1x protocol - enable or disable 802.1x protocol.
Radius Server IP - set the Radius Server IP address.
Server Port - set the UDP destination port for authentication requests to the specified
Radius Server.
Accounting Port - set the UDP destination port for accounting requests to the
Waters Network Systems
Figure 5.37 - X-ring Interface
Authentication is supplied through user name and
GSM2109-1009-8PoE User's Manual Page 71