System Event Log - Smtp Configuration - Waters Network Systems GSM2109-1009-8PoE Operating Manual

Note: When the Syslog Client Mode is set as Client Only, the system event log will
only be sent to the client logged into the switch. When the Syslog Client Mode is set
to Server Only, the system log will only be sent to the to the syslog server. You will
have to enter the IP address in the Syslog Server IP address column. If the Syslog
Client Mode is set to Both, the system log will be set to the client and server.
5.11 System Event Log – SMTP Configuration
The SMTP Configuration provides set up for the following:
Email alert – enable or disable the email alert function
SMTP Server IP – set up the mail server IP address. When Email Alert is enabled,
this function is available for set up.
Sender – Enter an alias with a complete email format to identify the event log
Authentication – Click the checkbox to enable this function. Once it is enabled,
configure the email account and password for authentication. Email alert must be
enabled to use this function
Mail Account – Set up the email account to receive the alert. It must be an existing
email account on the mail server which has been set in the SMTP server IP column.
Waters Network Systems
Figure 5.10 – System Event Log
GSM2109-1009-8PoE User's Manual Page 34