Table of Contents
Advertisement
Power Connection Guidelines for AC-Powered Systems
• The AC power receptacles used to plug in the chassis must be the grounding type. The grounding
Power Connection Guidelines for AC-Powered Systems
This section provides the basic guidelines for connecting the Catalyst 6880-X switch AC power supplies to
the site power source:
• Each chassis power supply should have a separate, dedicated branch circuit.
• For North America:
• For International:
• If you are using a 200/240 VAC power source in North America, the circuit must be protected by a
• The source AC outlet must be within 6 feet (1.8 meters) of the system and should be easily accessible.
• The AC power receptacles used to plug in the chassis must be the grounding type. The grounding
Power Connection Guidelines for DC-Powered Systems
This section provides the basic guidelines for connecting the Catalyst 6880-X switch DC-input power supplies
to the site power source:
• All power connection wiring should conform to the rules and regulations in the National Electrical Code
• The DC return must remain isolated from the system frame and the chassis (DC-I).
• For DC power cables, we recommend that you use commensurately rated, high-strand-count copper
• The color coding of the source DC power cable leads depends on the color coding of the site DC power
• DC power cables must be terminated by cable lugs at the power supply end.
Catalyst 6880-X Switch Hardware Installation Guide
28
conductors that connect to the receptacles should connect to protective earth ground at the service
equipment.
◦ The 3000 W power supply requires a 20 A circuit.
◦ Circuits should be sized according to local and national codes.
two-pole circuit breaker.
conductors that connect to the receptacles should connect to protective earth ground at the service
equipment.
(NEC), as well as any local codes.
wire cable. Connection to the DC-input power supply requires one earth ground cable, one source DC
(–), and one source DC return (+). The length of the cables depends on your switch location. These
cables are not available from Cisco Systems. They are available from any commercial cable vendor.
source. Typically, green or green and yellow indicate that the cable is a ground cable. Because there is
no color code standard for source DC wiring, you must ensure that the power cables are connected to
the DC-input power supply terminal block in the proper (+) and (–) polarity. In some cases, the source
DC cable leads might have a positive (+) or a negative (–) label. This label is a relatively safe indication
of the polarity, but you must verify the polarity by measuring the voltage between the DC cable leads.
When making the measurement, the positive (+) lead and the negative (–) lead must always match the
(+) and (–) labels on the DC-input power supply terminal block.
Preparing for Installation
OL-30827-02
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Catalyst 6880-X and is the answer not in the manual?
Questions and answers