Table of Contents
Advertisement
Digital Video Security Systems
Junction Box Installation
The camera is compatible with 2S and Two Gang junction boxes.
To install the camera to a junction box:
1. Connect the camera termination cable to the extension cables inside the junction
box.
2. Run the camera termination cable through the camera base.
3. Attach the camera base to the junction box according to the junction box type used
(see below).
2S Junction Box
(requires 2x screws)
NOTE: Screws are not provided for junction box
installation.
Ensure the rubber gasket is firmly
attached to the camera base to ensure
the weatherproof rating of the camera.
4. Connect the camera cable to the termination
cable and push the cable connection point
through the camera base into the junction box.
5. Use the included allen key to loosen the dome
cover screws (3x) and then remove the dome
cover from the camera module.
6. Attach the camera module to the camera base
using the machine screws M4x10 (3x).
Go to "Adjusting the Camera" on page 11.
Two Gang Junction Box
(requires 4x screws)
- 10 -
Camera
Termination Cable
Camera Cable
Rubber Gasket
Camera Base
Junction Box Screw
(Not included; 2x or 4x)
Camera Module
Machine Screw
M4x10 (3x)
Dome Cover
Advertisement
Table of Contents
