Table of Contents
Advertisement
Digital Video Security Systems
Day&Night
The Day&Night sub-menu allows you to configure day and night modes.
1. Press Up/Down to select Day&Night.
2. Press Left/Right to select one of the following modes:
• Color: Image will always be in color (day mode).
• B/W: Image will always be in black & white (night mode). Press Set Up to
enter the B/W sub-menu.
» Burst: Press Left/Right to select Off to eliminate the burst signal or
On to allow the burst signal.
» IR Smart: Press Left/Right to select On to enable Smart IR
compensation or Off to disable. Smart IR will prevent the image from
becoming overexposed if objects come too close to the camera at night. If
set to On, press Set Up to configure the following:
» Value: Press Left/Right to adjust the amount the camera will
compensate for IR saturation.
» Area: Press Set Up to adjust the area where the camera will apply Smart
IR compensation.
» IR DWDR: Press Left/Right to increase the level of D-WDR that will be
applied for Smart IR. This will brighten areas outside of the Smart IR area.
SETUP
LENS
DC
EXPOSURE
WHITE BAL
ATW
DAY&NIGHT
COLOR
3DNR
ON
SPECIAL
ADJUST
RESET
EXIT
DAY&NIGHT B/W
BURST
IR SMART
RETURN
- 24 -
OFF
ON
RET
Advertisement
Table of Contents
