FLIR DPV74TLUX Instruction Manual page 31

Digital Video Security Systems
• MOTION: You can set motion detection to highlight specific areas of the
screen when motion is detected. Press Left/Right to select ON to enable
motion detection or OFF to disable. If you select ON, press Set Up to
configure the following parameters:
TIP
• Motion detection settings are generally set separately on the DVR, where
they can trigger motion recording or other actions.
» Area: Press Left/Right to select areas 1~4.
» Area Display: Press Left/Right to select ON to enable the selected
area or select OFF to disable the selected area. To configure the area:
a. If ON is selected, press Set Up.
b. Press Left/Right/Up/Down to configure the position of the
motion area and then press Set Up to confirm.
c. Press Left/Right/Up/Down to configure the size of the motion
area and then press Set Up to confirm.
d. Press Set Up again to save changes.
» Value (Sensitivity): Press Left/Right to adjust the sensitivity of
the motion detection. The higher the setting "Value" is, the higher the
sensitivity for motion.
» Motion View: Press Left/Right to select ON to show highlights on
the monitor when the camera detects motion in the motion areas.
• Privacy: This allows you to hide up to 8 privacy areas on the monitor. Areas
designated as privacy areas will not be recorded. Press Left/
Right to select ON to enable privacy areas or OFF to disable. If ON is
selected, press Set Up to configure the following:
MOTION
AREA
AREA DISPLAY
VALUE
IIIIIIIIIIIIIIII IIII
MOTION VIEW
RETURN
- 30 -
1
ON
|
80
OFF
RET