Driver Installation And Advanced Settings; Setting For Receive Side Scaling - NEC Express5800/R140a-4 User Manual

DRIVER INSTALLATION AND ADVANCED SETTINGS

This section describes on how to install and setup various standard drivers mounted on the device.
For the information on installing and setting up the driver that is not described in this section, please
refer to the document attached to the driver.

Setting for Receive Side Scaling

You need to change setting for the factory-installed network adapters (Intel(R) PRO/1000 EB
Network Connection with I/O Acceleration and Intel(R) PRO/1000 EB Network Connection with
I/O Acceleration #2).
IMPORTANT:
perform the following steps before installing Intel(R) PROSet.
1.
Open [Control Panel]. Under [System and Maintenance], click [Open Device Manager] to
start [Device Manager].
2.
Open [Network adapters], and then double-click [Intel(R) PRO/1000 ∼].
3.
Select [Advanced], change [Receive Side Scaling] to "Disabled".
4.
Click [OK].
5.
Restart the system.
Now the setting is complete.
IMPORTANT:
[Receive Side Scaling] may not appear if the Intel(R) PROSet has
already been installed. In this case, you need to uninstall the PROSet
before changing [Receive Side Scaling]. See "PROSet" for how to
uninstall PROSet.
Installing Windows Server 2003 x64 Editions E-15
With Windows Server 2003 64-bit (x64) Editions,
With Windows Server 2003 64-bit (x64) Editions,