NEC Express5800/R140a-4 User Manual page 82

3-10 Setting Up Your Server
3.
Define the position of slide rail assembly so that the bottom of the rail bracket is located at
the lower position of the server.
IMPORTANT:
fails may protrude.
NOTES:
Check the direction of installing the slide rail assembly.
– Make the bracket face facing the outside of the rack.
– The slide rail has different shapes in its left and right side. Make
The front and rear supports of the rack have rectangular holes for
screw fastening. For the NEC rack, round stamps are provided in 1U.
As shown in the figure, locate the slide rail assembly so that a stamp
is positioned at the tip of slide rail assembly (lower side).
The rail bracket has 3U high.
Make sure that the fingers are locked in the rectangular holes.
If the slide rail is inclined during installation, inner
sure the stamp on the rail (Front → L / Front → R).
Make sure that the
fingers are locked in
the rectangular holes.
Stamp (located at the
lower right position of
slide rail assembly)