Waste Ink Pads - Epson Stylus Photo PX650 Service Manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635

Route the cable of the CD-R Sensor as shown below.
Printer front bottom left
Figure 4-106. Installing the Front Paper Guide Assy (1)

See Fig. 4-104 and install the PF EJ Ground Spring.

Make sure the four tips of the Front Paper Guide Pad are
placed on the Waste Ink Pad.
Bottom Side
Tip of Front Paper
Guide Pad
Figure 4-107. Installing the Front Paper Guide Assy (2)
A D J U S T M E N T 
After removing/replacing the Front Paper Guide Assy, make
R E Q U I R E D
the specified adjustments. (See

After replacing the Front Paper Guide Assy, be sure to perform
the required lubrication. (See
DISASSEMBLY AND ASSEMBLY
Pull out the cable here
Waste Ink Pad Position
Tip Tip
Chapter 5 "ADJUSTMENT".)
Chapter 6 "MAINTENANCE".)
Disassembling the Printer Mechanism

4.4.14 Waste Ink Pads

 Parts/Components need to be removed in advance
Upper Housing / Scanner Unit / Panel Unit / M/B Cover / Waste Ink Tray Assy /
Middle Housing / Printer Mechanism
 Removal procedure
C A U T I O N
When removing the Waste Ink Pads, take extra care not to
contaminate the surrounding objects with waste ink.
1. Remove Waste Ink Pads (x3) from the Lower Housing.
Figure 4-108. Removing the Waste Ink Pads
Place the Waste Ink Pads (x2) by pushing them along the cut
portions to the full and make sure that they are free from floating.
A D J U S T M E N T
After removing/replacing the Waste Ink Pads, make the specified
R E Q U I R E D
adjustments. (See Chapter 5
Revision C
Waste Ink Pads
"ADJUSTMENT".)
Confidential
105