Epson Stylus Photo PX650 Service Manual page 103

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635
 Removal procedure
1. Remove torsion springs (x3) at the rear of the printer.
Rear Spring
PE Sensor
Figure 4-99. Removing the Upper Paper Guides (1)
C A U T I O N
The mist sheet A and B may be deformed or damaged when once
removed. If these are deformed or damaged, replace them with a
new one.
2. Peel off the mist sheet A and mist sheet B with a tweezer or a similar tool.
Rear
Mist sheet A
Mist sheet B
Figure 4-100. Removing the Upper Paper Guides (2)
C A U T I O N
When removing the Upper Paper Guides, put down the actuator
of the PE Sensor toward the front to avoid damaging it.
DISASSEMBLY AND ASSEMBLY
Upper Paper Guides
Disassembling the Printer Mechanism
3. Release the hooks (x3), release the Upper Paper Guides from the shaft holders of
the printer frame, lower the actuator of the PE Sensor, and remove the Upper
Paper Guides. (See Figure 4-99.)
Release the hooks and lift
the Upper Paper Guides
Hook
Figure 4-101. Removing the Upper Paper Guides (3)
Install the springs properly, while paying attention to the tip
position of each spring.
Rear
Figure 4-102. Installing the Upper Paper Guides
A D J U S T M E N T
After removing/replacing the Upper Paper Guides, make the
R E Q U I R E D
specified adjustments. (See
C A U T I O N Put down the actuator
Front
Hook
Spring
Tip of spring
Chapter 5 "ADJUSTMENT".)
Confidential
Revision C
103