Pg Adjustment - Epson Stylus Photo PX650 Service Manual

Color inkjet printer
Hide thumbs Also See for Stylus Photo PX650:
Table of Contents

Advertisement

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635

5.3 PG Adjustment

Described below is the platen gap (PG) adjustment.
 Purpose:
Adjust the distance between the head surface and the Front Paper Guide Assy
(platen) properly and adjust the parallelism on the 0-digit side and on the 80-digit
side to ensure reliable print quality.
Once the CR Unit and/or Adjustment Bushes have been removed or whenever
necessary for any other reason, make this adjustment to correct the deviation of the
platen gap.
Table 5-5. PG Positions
Application for Printing
PG Size
Position
(selected from PG flag list for
(mm)
normal/head rubbing)
PG-
EPSON special thick paper
1.2
<APG Home>
PGPP, Postcards, Matte, etc.
Plain paper
PG typ.
<Mechanical
1.7
EPSON special thin paper, SF, etc.
default>
Rubbing with PG1.2 is avoided
Envelopes
PG+
2.35
Rubbing with PG1.2 and 1.7 is avoided
PG++
4.2
CD-R printing
 Things to be used
Thickness gauge:
1.15 mm (x2)
1.3 mm (x2)
Phillips screwdriver
ADJUSTMENT
C A U T I O N
C H E C K
P O I N T
Sequence
Application
Cleaning
CR measurement,
VH detection
CR home position
seek
At ink replacement
PG Adjustment
The thickness gauge to be used must be free from dust and dirt
and from deformation. Be sure to clean it before use.
Take care that the Printhead is not soiled or scratched.
To ensure high accuracy of adjustment, install new ink
cartridges in the carriage, and move the carriage right and left
by pulling the belt without holding the carriage.
Make this adjustment after installing the mechanism unit in the
Lower Housing. (Install the Linear Scale after adjustment.)
Refer to
"4.4.3 Printer Mechanism" (p.88)
With Epson Stylus Photo PX650/TX650/TX659/PX660, four
stages of PG setting are available by means of the APG
Mechanism. However, make this adjustment with the
mechanism in the minimum PG position (PG-: 1.2 mm).
(Refer to
"4.4.8 APG Unit" (p.95)
Locating hole
Locating hole
Figure 5-8. PG Position at PG Adjustment
Revision C
and below.)
120
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents