Epson Stylus Photo PX650 Service Manual page 71

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635

When installing the Scanner Unit, route the following cables
through the grooves and ribs of the Middle Housing, and secure
the FFC with double-sided tape.
Cable/FFC
Scanner FFC
Scanner CR Encoder Cable
Scanner CR Motor Cable
Grounding wire
Rear left
Insert slack cables
and FFCs into hole
Groove B
Groove C
Groove D
Groove
Rib
Double-sided tape
Figure 4-21. Routing the Cables
DISASSEMBLY AND ASSEMBLY
Number of double-
Groove Number of Rib
sided tape
A 5 2
B 5 ---
C 5 ---
D 7 ---
Groove A
Removal of Exterior Parts

After routing the cables, put the ferrite core of the Scanner CR
Motor cable in the groove of the Middle Housing.
4-19.)

After routing the cables, secure them with acetate tape and
double-sided tape as shown in Fig.

After routing the cables from the Main Board side, insert the
slack cables and FFCs into the hole on the Middle Housing.
(See Figure 4-21.)
Revision C
(See Figure
4-19.
71
Confidential