Disassembly Of Scanner Unit; Scanner Housing - Epson Stylus Photo PX650 Service Manual

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635

4.5 Disassembly of Scanner Unit

4.5.1 Scanner Housing

 Parts/Components need to be removed in advance
Upper Housing / Scanner Unit
 Removal procedure

C A U T I O N
Once the Scanner Housing is removed, there is a possibility that
dust and dirt may enter the inside of the scanner body. Perform
disassembly and assembly of the Scanner Unit in a clean room
or on a clean bench to keep away from dust and dirt.

Perform disassembly and assembly with care not to damage the
document table (glass). It may require considerable time to
clean if dirt sticks to the inside of the document table.

Take care in handling the Lower Housing. Because grease is
applied to the CR guide area of the Lower Housing, do not
touch any parts with a greasy hand or part.

Take care not to contaminate or scratch the Encoder Scale or
the lens of the CIS Unit.
C A U T I O N
Lubrication Point
C A U T I O N Do not contaminate or scratch the scale
Figure 4-109. Scanner Unit
DISASSEMBLY AND ASSEMBLY
C A U T I O N Do not contaminate or scratch the lens
Disassembly of Scanner Unit
1. Remove the screws (x7) on the bottom of the Scanner Unit.
2. Remove the Scanner Housing, the hinge area in the rear of the Scanner Unit first.
Remove the hinge side first
3
1
5
Figure 4-110. Removing the Scanner Housing

When installing the Scanner Housing, engage the hooks (x4) in
the front properly first and then engage the hinge area in the
rear. (See Figure 4-110.)

Tighten the screws in the order given in
A D J U S T M E N T
When the CR Unit is removed in subsequent work or for some
R E Q U I R E D
other reason, the scanner origin can be shifted from the correct
position; therefore, adjust the origin location after re-installation.
Refer to "5.5 Scanner Original Adjustment"
Revision C
7
6
2
4
Hook
C.B.P. 2.5x10 (5±1 Kgfcm9)
Fig. 4-110.
(p.127).
106
Confidential