Epson Stylus Photo PX650 Service Manual page 154

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635
2. Remove the screws (x6) that secure the Printer Mechanism and lift the Printer
Mechanism upward to remove it.
5
4
C.B.P.(P2). 3x8 (6.1±1 Kgfcm)
Figure 8-19. Removing the Printer Mechanism (3)

When installing the Printer Mechanism, put the ferrite core of
the CR Motor Cable in the groove of the Lower Housing, and
secure it with acetate tape.

Tighten the screws in the order given in
Epson Stylus Photo PX660/PX660 Premium/Artisan 635
6
3
1
2
(See Figure 8-18.)
Fig. 8-19.
Disassembly/assembly

Before installing the Printer Mechanism, make sure that the
Stacker Assy operates properly with the switching of the
Stacker Lever. If it does not operate properly, check the phases
of the Stacker Lever on the left side of the Lower Housing, the
Combination Gear 14.4,45.6, and the Link Stacker, and install
them to be aligned correctly.
ASF position Combination Gear 14.4,45.6
Link Stacker
Align the phases
CDR position
Figure 8-20. Phase Adjustment of the Stacker Assy

A D J U S T M E N T
After removing/replacing the Printer Mechanism, make the
R E Q U I R E D
specified adjustments. (See

After replacing the Printer Mechanism, be sure to perform the
required lubrication. (See
Revision C
Stacker Assy
Stacker Lever
Stacker Assy
Stacker Lever
"8.3 Adjustment" (p.157).)
Chapter 6 "MAINTENANCE".)
154
Confidential