Epson Stylus Photo PX650 Service Manual page 70

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635
4. Peel off the acetate tape, and release the all cables and FFCs of the Scanner Unit
from the grooves and ribs of the Middle Housing.
5. Pull out the Scanner FFC from the Ferrite Core A.
Put ferrite core of Scanner CR
Motor Cable in groove here.
Ferrite Core A
Acetate tape
Figure 4-19. Removing the Scanner Unit (2)
DISASSEMBLY AND ASSEMBLY
C H E C K
P O I N T
6. Pull out the hinge of the Scanner Unit on the left side.
7. While keeping the Scanner Unit open at 45 degrees, push it in the direction of the
arrow as shown in
Left
Hinge
Groove and Rib
Double-sided tape
Removal of Exterior Parts
If you remove the Upper Housing using the L-shaped screwdriver,
the stubby driver or a similar tool (p.66), the Scanner Unit is
secured with the screws. Make sure to remove the screws (x2) that
secure the Scanner Unit before taking the following steps.
Figure 4-11.)
Fig. 4-20 to remove the Scanner Unit from the right hinge.
Scanner Unit
Hole
Figure 4-20. Removing the Scanner Unit (3)
Revision C
(See
Right
Groove
Rib
Hinge
70
Confidential