Epson Stylus Photo PX650 Service Manual page 86

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635
7. Remove the screws (x3) that secure the Printhead, and lift the Printhead upward.
2
3
Figure 4-55. Removing the Printhead
8. Disconnect the Head FFCs (x2) from the connectors (x2) on the rear of the
Printhead, and remove the Printhead.
C A U T I O N Do not touch nozzle surface
Figure 4-56. Releasing the Head FFCs
DISASSEMBLY AND ASSEMBLY
Printhead
1
A D J U S T M E N T Head ID
R E Q U I R E D
C.B.P. 2.6x8 (4±1 Kgfcm)
Head FFC
Disassembling the Printer Mechanism

Make sure that the FFC is connected properly.

Tighten the screws in the order given in

Install the Head FFC Cover and Head Cable Cover as shown
below.
Head FFC Cover
The bottom protrusions (x2) and the top
sliding sections (x2) must be in
alignment.

A D J U S T M E N T
For replacing the Printhead, note down the head ID before
R E Q U I R E D
installing the Printhead.

After removing/replacing the Printhead, make the specified
adjustments. (See Chapter 5
Revision C
Fig. 4-55.
Head Cable Cover
Engage the protrusion in the rear with the
carriage first and then insert the top
protrusions (x2) to the hole of the carriage.
"ADJUSTMENT".)
86
Confidential