I Auto-Memory Write Scan - Icom IC-R20 Instruction Manual

I Auto-memory write scan

This scan is useful for searching a specified frequency range
and automatically storing busy frequencies into memory
channels. The auto-memory write scan is performed any VFO
scan types (ALL, BAND, PROG).
q Select VFO mode with [VFO MHz].
wPush and hold [MODE SCAN] to enter scanning type se-
lection condition.
e Rotate [R-DIAL] to select the desired scanning type.
• "ALL" for full scan; "BAND" for band scan, "PROG-xx" for pro-
grammed scan (xx= 0 to 24; programmed scan edges numbers
only displayed)
r Release [MODE SCAN] to start the scan.
tPush [MR S.MW] to turn the automatic memory write func-
tion ON and OFF.
• "µ " indicator blinks.
[R-DIAL]
MODE
SCAN
MR
S.MW
yPush [DUALWATCH] to stop the scan.
• During auto memory
write scan
148 800
√ µ 001
µ
" " indicator blinks during
auto memory write scan.
D D During auto-memory write scanning:
• When signal is received, scan pauses and the frequency is
stored into auto-memory write channel group (å 000–199).
- 2 short beeps sound when stored.
• Scan resumes after frequency storing.
• When all channels are stored, the scan is canceled auto-
matically and 1 long beep sounds.
D D Recalling the stored frequencies:
qPush [MR S.MW] several times to select the auto-memory
write channel group.
å
• " " appears.
e Rotate [R-DIAL] to select the desired channel.
439 875
√
" å
" appears when auto memory
write channel group is selected.
D D Clearing the stored frequencies:
q Select the auto-memory write channel group.
wPush [5 SKIP] for 1 sec. to clear the all channels contents.
• 1 short and 1 long beeps sound.
NOTE: The auto-memory write channel contents CANNOT
be cleared by an independent channel. Thus it is good idea
to copy the contents into regular memory channel.
SCAN OPERATION
å 001
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
38