Lighting Systems; Cabin Light - Head; Navigation And Anchor Lights - Pro-Line Boats 2009 20 Sport Owner's Manual

Sport fishing boat

Hide thumbs

Table Of Contents

Table of Contents

Honda, etc.), this switch will not illuminate the gauge lights. Instead, your

gauge lights will be illuminated when the ignition switch is turned on.

•

Middle position – All lights are off.

•

Back/Aft position – Anchor light is on; the bow lights and gauge lights are off.

Bilge Pump - Your boat is equipped with an automatic bilge pump and float switch. This 1100 gph pump is

located in the bilge and is mounted as far aft as possible. The bilge pump and float switch are accessible

via the hatch that is installed in the center of the motor well. The bilge pump is wired automatic to the

battery and has a manual override located at the switch panel on the console. The automatic float switch is

wired directly to the Starboard battery terminals through breakers or inline fuses. The circuit breaker is

located at the helm next to the manual switch. Depressing the bilge pump switch to the up or forward

position activates the bilge pump.

Baitwell Pump - The baitwell pump is located in the bilge area and is plumbed to a seacock (ball valve).

This pump is also used for the raw water washdown. See the Sea Water section of this manual for

instructions on using the raw water washdown fitting.

For the pump to operate properly you need to make sure the seacock is in the open position. The seacock

is wide open when the yellow seacock lever is vertical. When the yellow seacock lever is horizontal, the

seacock is closed.

The underside of the seacock thru-hull is equipped with a scoop to allow the water to be picked up even

when the boat is on plane. When the boat is not in the water or the baitwell pump is not going to be used

for an extended period of time, the seacock valve should be in the closed position. To activate the pump,

depress the switch to the up or forward position. To turn the pump off after the baitwell tub is full, depress

switch to the down or aft position.

Fresh Water (Optional) – The fresh water switch provides power to the fresh water pump. Depress the

fresh water switch to the forward position to activate the fresh water pump. The fresh water faucet/nozzle

is installed behind a white rubber cap located just out side the transom door. Press the button on the

handle to activate the faucet/nozzle. If the fresh water system is not going to be in use, stow away the

hose and move the switch to the aft or down position to turn the pump off.

Cockpit Lights (Optional) – Your vessel may be equipped with cockpit/ courtesy lights. The lights have LED

(light emitting diode) bulbs with a lifespan of approximately 10,000 hours. To activate the lights, depress

the switch to the up or forward position. The lights give off a soft warm light which should not affect your

night vision, but will still provide you with enough light to safely move around your cockpit in low visibility

conditions.

Baitwell Light - To activate the baitwell light, depress the switch to the up or forward position. This will

activate the LED (light emitting diode) light inside your baitwell tub. It is a soft white light that will keep your

bait moving and lively. It will also help you locate your bait on those early morning or late night fishing trips.

To turn the light off, simply depress the switch to the down or aft position.

Accessory – These 5 amp accessory switches can be used for additional dealer installed accessories.

Please check the amp rating of any new component and/or additional accessory before installation.