Isinglass; Rigid T-Top; Vinyl; Exterior Vinyl - Upholstered Seats And Cockpit Bolsters - Pro-Line Boats 2009 20 Sport Owner's Manual

•
Rinse thoroughly.
•
Air dry.
•
Repeat if necessary.
Re-treating the Fabric - Sunbrella fabrics are treated with a fluorocarbon finish to enhance water repellency. This
finish is designed to last for several years, but must be replenished after a thorough cleaning. Based on test
results, Glen Raven recommends
Sunbrella fabrics. Fabrics should be retreated after thorough cleaning or after five years of use. Check with your
local Sunbrella dealer or distributor for additional information.
For more information, visit the Sunbrella website at www.sunbrella.com for specific recommendations.
Isinglass (Windscreen Material)
Maintenance means "rinsing" with cold water and trying not to rub the dirt into the Isinglass. Never "Dry" dust the
Isinglass panels. Any rubbing acts like sandpaper to plastic so keep rubbing to a minimum. Always use lots of
cold water and a very very soft cloth when rubbing is required. Do not use paper towels or Terri-cloth towels. Try
not to use any cleaning solutions, as most will cause yellowing and cracking.
When you have to store the panels of your windscreen and curtain package, always "roll up" the material to
prevent creases. Do not fold the Isinglass as this will permanently damage the Isinglass material. Do not roll up
the panels when wet, as the material will turn white or fog up. Dry the panels off first using a very very soft cloth
before rolling them up. A few hours in the sun will get rid of the whiteness or fogginess in most cases.

Rigid T-Top

If you have selected the rigid T-Top, your new top is made from Trylon.
Fiberglass. It will give you years of trouble free service with a few simple steps.
•
Clean the rigid T-Top with soap and water. You may use denatured alcohol for hard to remove
stains.
•
Never clean using acetone or other harsh solvents, as this will damage your rigid T-Top.
•
Your rigid T-Top can be waxed using a standard non-abrasive automobile wax.
•
If you should need to tighten the rigid T-Top to the frame, use care not to over stress or deform
the top as this can cause failure over time. The top should be snug but not deformed by the
fasteners.

Vinyl

Exterior Vinyl – Upholstered Seats and Cockpit Bolsters
Vinyl requires periodic cleaning to maintain its neat appearance and to prevent the build-up of dirt and
contaminants that may permanently stain and reduce the life of the vinyl if they are not removed. The frequency
of cleaning depends on the amount of use and on environmental conditions to which the vinyl is subjected. The
procedures used for cleaning are dependent upon the end use circumstances.
For normal cleaning, most stains can be cleaned using warm soapy water and a clear water rinse. Moderate
scrubbing with a medium bristle brush will help to loosen soiling material from the depressions of embossed
surfaces. For stubborn stains, use either Fantastic or Mr. Clean, which are commercially available mild
detergents, in accordance with manufacturers instructions.
For additional information regarding the care and maintenance of this product, please refer to the Morbern
brochure provided in your owner's package for recommended methods to clean specific types of stains.

Corrosion Protection

Spray all electrical connections with a good quality corrosion guard annually and whenever an electrical
connection is repaired or replaced.
303 High Tech Fabric Guard™ as the preferred re-treatment product for
This is a composite plastic not
36