Removing An Lc-Lc Cable From An Lc-Sc Cable Adapter; Removing The Lc-Sc Cable Adapter Protective Caps; Connecting An Lc-Lc Cable Into The Lc-Sc Cable Adapter - IBM TotalStorage DS4100 Installation, User's, And Maintenance Manual

3. Remove the two protective caps from the LC connector end of the LC-SC cable
Figure 46. Removing the LC-SC cable adapter protective caps
4. Carefully insert the other end of the LC-LC cable into the LC connector end of
Figure 47. Connecting an LC-LC cable into the LC-SC cable adapter
5. If you are connecting the DS4100 to a 1-Gbps fibre channel switch or fibre

Removing an LC-LC cable from an LC-SC cable adapter

Complete the following steps to remove an LC-LC cable from an LC-SC cable
adapter:
Attention:
the lever to release the latches before you remove the cable from an LC-SC cable
adapter. Ensure that both levers are in the released position when removing the
cable. When removing the cable from the SFP module, make sure you do not grasp
the SFP module plastic tab.
54
IBM TotalStorage DS4100 Storage Server: Installation, User's, and Maintenance Guide
adapter as shown in Figure 46. Save the protective caps for future use.
the LC-SC cable adapter as shown in Figure 47. Push in the connector until it
clicks into place.
channel host bus adapter, connect the SC connector end of the LC-SC cable
adapter to a Gigabit Interface Converter (GBIC) that is installed in the 1-Gbps
fibre channel switch or fibre channel host bus adapter. For more information
about connecting to these devices, see the documentation that comes with the
device.
To avoid damaging the LC-LC cable, make sure you press and hold