Removing An Lc-Lc Cable From An Lc-Sc Cable Adapter; Removing The Lc-Lc Fibre Channel Cable From An Lc-Sc Fibre Channel Cable Adapter - IBM TotalStorage DS4400 User Manual

Removing an LC-LC cable from an LC-SC cable adapter

To remove an LC-LC cable from an LC-SC cable adapter, do the following:
Attention:
the lever to release the latches while you remove the cable from an LC-SC cable
adapter. Ensure that both levers on the LC-LC cable are in the released position
when removing the cable.
1. On the end of the cable that connects into the LC connector end of the LC-SC
Figure 15. LC-LS Fibre Channel Cable lever and latches
2. Carefully pull on the connector to remove it. Make sure you grasp the connector
Figure 16. Removing the LC-LC Fibre Channel cable from an LC-SC Fibre Channel cable
adapter
3. Replace the protective caps on the cable ends.
For more information about connecting to these devices, see the documentation
that comes with the device.
To avoid damaging the LC-LC cable, make sure you press and hold
cable adapter, press down and hold the lever to release the latches. Figure 15
shows the location of the lever and latches.
Lever
Latches
and not the cable when removing the LC-LC cable from the LC-SC cable
adapter, as shown in Figure 16.
13
Chapter 1. Introduction