Removing An Lc-Lc Cable From An Lc-Sc Cable Adapter; Removing The Lc-Sc Cable Adapter Protective Caps; Connecting An Lc-Lc Cable Into The Lc-Sc Cable Adapter - IBM TotalStorage FAStT700 Installation Manual

2. Connect an LC-LC cable to an SFP module in the FAStT700 Storage Server
3. Remove the two protective caps from the LC connector end of the LC-SC cable,
Figure 22. Removing the LC-SC cable adapter protective caps
4. Carefully insert the LC connector end of the cable into the LC connector end of
Figure 23. Connecting an LC-LC cable into the LC-SC cable adapter
5. Connect the SC connector end of the LC-SC cable to one of the following

Removing an LC-LC cable from an LC-SC cable adapter

To remove an LC-LC cable from an LC-SC cable adapter, do the following:
®
24
™
IBM TotalStorage FAStT700 Fibre Channel Storage Server: Installation Guide
mini hub. For instructions, see "Connecting an LC-LC cable to an SFP module"
on page 19.
as shown in Figure 22. Save the protective caps for future use.
the LC-SC cable adapter. Push in the connector until it clicks into place.
devices:
v Optical interface connector on an IBM FAStT FC-2 Host Bus Adapter (Part
number 19K1246)
v GBIC installed in a FAStT EXP500 expansion unit (Machine type 3560)
v 1 Gb Fibre Channel switch (Machine type 2109)
For more information about connecting to these devices, see the documentation
that comes with the device.