Table of Contents
Advertisement
Removing a hot-swap power supply
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact a
service technician.
To remove a hot-swap power supply:
1. Turn off the ac power switch.
2. Unplug the power cord from the electrical outlet.
3. Disconnect the power cord from the ac power connector on the power supply.
4. Remove the nut and strain-relief clamp from the rear of the power supply.
5. Remove the power supply from the storage server, as follows:
Lever
AC power
Strain
-
connector
relief clamp
a. Grasp the pull-ring on the power-supply lever, and squeeze the latch to
release it.
b. Pull the lever open and remove the power supply.
AC power
switch
Chapter 5. Installing and replacing components
49
Advertisement
Table of Contents
