Table of Contents
Advertisement
Replacing a processor
Make sure the processor is fully seated in its socket and that the goal post
latches are engaged.
Important:
Replacing a system board
Important:
Notes:
1. The BIOS and Vital Product Data (VPD) for the computer you are
servicing must be installed on the new system board (FRU) after it is
installed in the computer. To do this, you must run the Flash Update
program using the Flash Update diskette. See "BIOS levels" on page 129,
"Vital product data" on page 127, and "Flash (BIOS/VPD) update
procedure" on page 130.
2. Always ensure the latest level of BIOS is installed on the computer. A
down level BIOS may cause false errors and unnecessary replacement of
the system board.
3. The processor is a separate FRU from the system board and is not
included with the system board FRU. If you are instructed to replace the
system board, use the following procedure.
a. Remove the processor from the old system board and install it on the
new system board.
b. Remove any of the following installed options on the old system
board, and install them on the new system board.
v Memory modules
c. Ensure that the new system board jumper settings match the old
system board jumper settings.
d. If the new system board does not correct the problem, reinstall the
options on the old system board, reinstall the old system board, then
replace the processor.
Security features
Security features in this section include the following:
v Passwords
v Make sure the air baffle is installed to prevent processor
overheating.
v If the processor is not installed correctly, the system board and
the processor can be damaged.
Before replacing a system board, back up Asset information with
PC-Doctor by using the "Asset EEPROM backup" on page 120.
Chapter 3. Types 6058/6059/6269/6578/6579
125
Hide quick links:
Advertisement
Table of Contents
