IBM NetVista 6058 Hardware Maintenance Manual page 92

POST Error Code
1207
13XX
1402Printer not ready
1403No paper error, or interrupt failure
1404System board timeout failure
1405Parallel adapter error
1406Presence test error
14XXNot listed above. Check printer before
replacing system board
15XX
1692Boot sequence error
16XX
1762Hard disk drive configuration error
1780 (Disk Drive 0)1781 (Disk Drive 1)1782 (Disk
Drive 2)1783 (Disk Drive 3)
180X, 188XPCI configuration or resource error
1962Boot sequence error
209X
78
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649
FRU/Action
1. Communications Cable
2. Dual Async Adapter/A
1. Game Adapter
Information only
Information only
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1. Printer
2. System Board
1. SDLC Adapter
1. Run FDISK to ensure at least one active
partition is set active
1. 36/38 Workstation Adapter
1. Run Configuration (See "Setup Utility
program" on page 41)
1. See "Power supply" on page 30
2. Hard Disk Drive
3. System Board
4. Riser card
5. Hard Disk Cable
6. Power Supply
1. Run Setup and verify PCI/ISA configuration
settings.
2. If necessary, set ISA adapters to Not available to
allow PCI adapters to properly configure.
3. Remove any suspect ISA adapters.
4. Rerun diagnostics.
5. PCI Adapter
1. Possible hard disk drive problem; see "Hard
disk drive boot error" on page 42
1. Diskette Drive
2. Diskette Cable