IBM NetVista 6058 Hardware Maintenance Manual page 22

Diagnostic Error Code
011-013-XXX
011-014-XXXSerial port Control
Signal/Loopback test failure
011-015-XXXSerial port External Loopback
failure
011-027-XXXSerial port Configuration/Setup
error
011-03X-XXX
011-04X-XXXSerial port failure
011-195-XXXSerial port Test aborted by user
011-196-XXXSerial port test halt, error
threshold exceeded
011-197-XXXSerial port test warning
011-198-XXXSerial port test aborted
011-199-XXXSerial port test failed, cause
unknown
011-2XX-XXXSerial port signal failure
014-000-XXXParallel port Interface Test Passed
014-001-XXXParallel port Presence
014-002-XXX
014-003-XXXParallel port Timeout/Parity error
8
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649
FRU/Action
1. System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system
3. System board
1. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems" section
1. Go to the "Undetermined problems" section
2. Flash the system and re-test
3. Replace component under function test
1. External serial device
2. System board
1. No action
1. Remove external parallel device, if present
2. Run setup, enable port
3. System board
1. System board