Simm/Dimm/Rimm Memory Errors - IBM NetVista 6058 Hardware Maintenance Manual

SIMM/DIMM/RIMM memory errors

SIMM/DIMM/RIMM error messages issued by the IBM PC Enhanced
Diagnostics.
Message
2xx-1y
2xx-2y
Corrupt BIOS
Test aborted by user
Note: Y is the SIMM/DIMM/RIMM socket number. Use the System Board
Failure Found
A memory error was detected in
SIMM socket Y.
A memory error was detected in
DIMM/RIMM socket Y
Information in BIOS is not as
expected.
Not able to find expected DMI
information from BIOS.
Memory controller chipset
vendor ID does not match
expected value.
User stopped test.
Layout section in the latest Hardware Maintenance Manual (HMM) to
reference the memory sockets.
Recommended Actions
Replace the SIMM in the socket
identified by the last digit of the
error code.
Re-run the test.
If the same error code occurs
again, replace the system board.
Replace the DIMM/RIMM in the
socket identified by the last digit
of the error code.
Re-run the test.
If the same error code occurs
again, replace the system board
or where memory is on the
processor card, replace the
processor card.
Reflash the BIOS.
Perform boot block recovery.
Replace the system board.
Restart test.
Chapter 3. Types 6058/6059/6269/6578/6579
121