IBM NetVista 6058 Hardware Maintenance Manual page 88

POST Error Code
164POST detected a base memory or extended
memory size mismatch error or RIMM socket 3 is
populated with a RIMM memory module
166Boot Block Check Sum Error
167Microprocessor installed that is not supported
by the current POST/BIOS
168Alert on LAN error
17X, 18X
175
176
177Corrupted Administrator Password
178
183
184No RFID Antenna
185Corrupted boot sequence
186
187
74
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649
FRU/Action
1. Run Setup. Check System Summary menu for
memory size change. (See "Setup Utility
program" on page 41.)
2. Run the Extended Memory Diagnostic tests
1. Run Flash Recovery using Boot Block. See
"Flash recovery boot block jumper" on
page 50.
2. System Board
1. Run Setup. Check Stepping level for the
BIOS level needed, then perform the flash
update.
2. Processor
1. Run Setup. Check to see that Ethernet and
Alert on LAN are enabled.
2. System Board
3. Riser card
1. C2 Security
1. Run Configuration. See "Setup Utility
program" on page 41.
2. System Board
1. Covers were removed from the computer
1. System Board
1. System Board
1. Enter the administrator password
1. Make sure Asset Care and Asset ID are
enabled in Configuration/Setup
2. RFID Antenna
3. System Board
4. Riser card
1. Set configuration and reinstall the boot
sequence
1. System Board
1. Clear Administration password
2. System Board