IBM NetVista 6058 Hardware Maintenance Manual page 20

Diagnostic Error Code
005-024-XXXVideo Addressing test failure
005-025-XXXVideo Checksum Value error
005-027-XXXVideo Configuration/Setup error
005-031-XXXVideo Device Cable failure
005-032-XXXVideo Device Controller failure
005-036-XXXVideo Register error
005-038-XXXSystem BIOS extension failure
005-040-XXXVideo IRQ failure
005-195-XXXVideo Test aborted by user
005-196-XXXVideo test halt, error threshold
exceeded
005-197-XXXVideo test warning
005-198-XXXVideo test aborted
6
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649
FRU/Action
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Run Setup
2. Video drivers update
3. Video card, if installed
4. System board
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems" section